Falc - cod. 2023 02/19
– Inglese -
8
a)
All Falc shredders may be applied to all types of tractors provided that they are equipped with a
universal 3 point linkage (see MINIMUM Power, Weight and Size of tractors).
b)
The shredder must be positioned level and in a stable position on the supporting leg.
c)
The tractor must reverse towards the shredder until its arms correspond to the shredder’s 3p
arms. Any operators on the ground must keep a distance of at least 5 metres from the machine
during this phase.
d)
Position the pins of the lower 3 point and lock with the split pins supplied.
e)
Connect the upper arm of the tractor to the upper pin of the 3 point, adjusting so that the
machine assumes a horizontal position with regards to the ground.
f)
Position the cardan shaft and check that its ends are properly connected with the tractor’s and
multiplier’s power take-off. Fix the anti-rotation chains present on the cardan on both the tractor
side and the shredder side.
The tractor engine must be off during this phase in order to
avoid any erroneous movement starting up the power take-off (PTO).
g)
Connect the hydraulic system tubes to the tractor’s distributor.
h)
Having carried out these operations it is possible to move the tractor’s lifter enough to free the
supporting foot which must be completely lifted and locked with the pin supplied.
i)
For the series’ machines: Tractor’s power take-off (PTO) = 550 cycles/minute
4.2. USING THE SHREDDER
