1 3
ZWK 10
1
2
3
2
3
4
In/Ex
Select
1
PRIMARY
SECONDARY
1X
1X
IN/EX
<1s
1
2
3
1X
1X
IN/EX
<1s
1X
I
II
3X
IN/EX
Controller programming – additional functions
Function allows for such configuration of devices
within one Z-Wave network that one controlled device
launch another device, not assigned to controller's
buttons of movement. An example is launching of one
servo-motor with the use of another servo-motor
equipped with a rain sensor.
On PRIMARY controller within 1 sec. press once
IN/EX button and once SELECT button.
LEDs 1 and 2 will light up.
Within 1 0 sec. press P button on the device
which is to be controlled until LEDs on the
controller change into 3 and 4.
Within 60 sec. press P button on the device
which is to be operated (see device manual) until
LEDs on the controller change into 1 ,2,3,4.
- If a given sequence of LEDs does not occur, it
is necessary to perform procedure again.
This function allows for copying group of devices from
PRIMARY controller to SECONDARY controller and
conversely within one network.
Associating Z-Wave devices
- ASSOCIATE DEVICE
Copying group of devices
- COPY GROUP
Choose channel and within 1 ,5 sec. press IN/EX
button 3 time on the controller no. I.
LEDs 1 and 3 will light up.
Within 1 0 sec. press STOP button the group
copied, until LEDs change to 3,4
Within 1 0 sec. choose channel and perform
ASSOCIATE function on the target controller (no.
II) by pressing IN/EX and STOP button of a
group to which device is to be copied. LEDs
change to 2,3,4 and on the controller no. I to
1 ,2,3,4.
- If a given sequence of LEDs does not occur, it
is necessary to perform procedure again.
