Accessories / Operating
14
1. Insert the required nozzle into the telescopic tube
or handle.
2. Pull out the power supply cable until the required
length is reached. A yellow mark on the cable
shows you that the maximum cable length has
almost been reached. The ma-ximum cable length
is shown by a red mark on the cable. Never pull
the cable out of the appliance beyond the red
mark.
3. Press the pedal button ON-OFF “
[A]
“ to switch
on the va-cuum cleaner.
4. Set the required suction level by using the suction
power regulator „
- / +
“
[C]
.
5. The suction control on the handle can be used to
regulate the suction power for short time. Use this
sliding control only for temporary reduction of the
suction power.
max
. Suction power =
Slider forward
(opening
slots
closed)
min
. Suction power
=
slider backward
(opening
slots
visible)
WARNING!
Always check the appliance and the power cable
before use. Faulty appliances may cause injury and
should not be used.
Vacuum cleaning
Filter change indicator
Notice!
n case of full dust bin, as well as filters and with
clogged up accessories (hose, tube, nozz-les), the
filter exchange indicator “
[D]
“ lights up. In order to
make an accurate evaluation, press press the switch
on the maximum vacuum power position and lift the
floor suction nozzle from the floor. In this case, replace
the dust bag and/or the clogged filters or remove the
stop page
D
A
