9
• Place the nozzle plate (base foot)
[2]
with pre-installed weight disc onto the
pedestal / telescopic tube
[3]
precisely
(the bars on the base foot have to
engage with the corresponding reces-
ses on the pedestal tube) and fix with
the included cap nut
[1]
and secure.
• Place the back protective grid
[5]
exactly onto the motor head
[4]
(insert
the three pins on the motor head into
the three holes in the protective grid)
and screw tightly using the included
cap nuts
[6].
• Screw out small M3 screw from outer
ring of the rear protective grid.
• If required, pull off the protective hose
from the motor axle.
• Place the fan blades
[7]
all the way
onto the motor axle and secure with
the included cap nut
[8].
•
Attention:
left-handed thread.
• Place the front protective grid
[9]
exactly into the upper bracket on the rear protective
grid
[5]
, push on and fix with the four swivel brackets (left and right). Fix both protective
grids at the bottom with the included M3 screw.
• Place the cooling fan with the control panel (motor head) onto the telescopic tube
[3]
and secure with the knurled screw
[10].
WARNING!
Never use a defective appliance.
WARNING!
Prior to assembly, make sure that the mains
plug is unplugged. If the mains plug is plug-
ged in, the appliance could accidentally be
switched on, resulting in injuries.
Assembly
Assembly
en
