19
USAGE
GB
Charging the batteries
Before first use as well as for the following chargements, the
appliance should be charged for 8 hours. Place the
appliance onto the charging base and then plug the mains
adaptor into the mains socket. A small red charge indicator
lamp (LED) indicates the charging process. The hair clipper
can be operated for approx. 50 minutes with a full charge.
To ensure a long service life of the batteries, they should
always be completely discharged before recharging them.
To discharge them completely, the appliance should be
operated until it comes to a complete standstill.
Using the hair clipper
For hair clipper, push the On/Off switch upwards to the
“On” position. It is recommended that the hair is initially not
trimmed too short.
Choose the transparent cutting length attachment with
lengths between 3mm and 15mm.
Plug the comb attachment onto the side rails of the
housing. An oval retention plate is located on the underside
of the unit. Turn it up and down to adjust the comb attach-
ment. Make sure that the attachment is always firmly locked
in before you start trimming hair.
If you would like to further shorten the hair, you can push
the comb attachment downward into another position to
repeat the cutting process.
After use, switch the hair clipper off by moving the On/Off
switch downwards into the “Off” position.
Before using the
hair clipper
The hair to be cut should be clean and dry or damp.
Carefully comb the hair to remove any knots. Place a towel
around the neck to prevent any trimmed hairs failing down
inside the collar.
To prevent the electric shock, never use the appliance near
water/liquids when it is connected to the mains supply.
