26
USAGE
GB
• Set the waste water container on the Clean water
container back.
• Fit the pump hose into the waste water container and turn
the hose right until it locks.
• Place the upper body again on the lower body and fit them
by closing the ratchets.
• Install the adaptor of suction hose to into the vacuum inlet
and lock it by turning right.
• Connect the tubes of vacuum hose and fix them by turning
the lock clamps right.
• Connect the handle with the tube and fix it by turning the
locking latch right.
• Assemle the chosen nozzle in the tube and fix it by turning
the lock latch right.
• Insert the extraction adaptor into the pump valve until it
locks and ensure that the extraction adaptor is locked by
pulling.
• Plug the cord into the power outlet.
• Turn the power switch on “VAC” position.
• Water extraction will start once pushing the buton on the
handle.
• Start the carpet cleaning at the most dirty areas. Push the
extraction button and vacuum at the same time by pulling
the tube at very dirty areas backwards. Repeat this until
the result is well.
• While moving the nozzle forward and backward during
extraction, you soften and Clean the dirts easily
• Drain the waste water container by refilling the fresh water
container. If the waste water container is full, the appliance
will start to be very loud and will vibrate. So swich off the
appliance directly.
• We advise to rinse the cleaned area with fresh water
again..
• For quick dry of your carpet and couch/sofa, you can turn
the switch to VAC Position and just vacuum the carpet and
couch/sofa.
• Do not forget to Clean your machine and the accesories,
after cleaning operation.
1. You can wash and Clean the water pump by injecting the
Clean water on the rinsing process.
2. Clean the accessories, pipes and Hose of the appliance.
3. To dry the suction hose and tube, operate the appliance
for 1-2 minutes.
4. Rinse and dry the waste water container after draining the
water.
5. Dry the fresh water container
