USAGE
GB
27
Before extraction deaning of carpeted floors or upholstery
check the color-fastness of the material. To do this apply
some of the concentrated cleaning agent to an in
conspicuous area with a cloth allow it to dry, then carry
out a color comparison. The floor covering or upholstery
should only be cleaned if no change of color is evident.
A- Tank -
Release the canister clamps, remove the hood,
cartridge filter and paper filter if fitted. To remove the filter
turn the filter retaining clip anticlockwise and pull off the
filter cartridge including the base plate.
B- Foam Plastic Filter -
Install the foam plastic filter by
pushing the filter completely onto the float valve retainer as
far as it will go. Now reinstall the hood on the canister,
fasten the canister clamps and install the extraction
cleaning accessories.
C-
Pressure Hose
D-
Insert the pressure hose in to the corresponding
aperture of the adapter supplied and secure to the suction
hose or suction tube at regular intervals. Insert the quick
release coupling at the end of the hose into the mating
socket in to the hood and push it home so that it locks.
The pressure hose connection can be straightforwardly
released. To do this push the corrugated sleeve of the
quick release coupling back so that the coupling is
automatically forced out under spring pressure.
E-
Spray Extraction Liquid Tank
Connection Hose - Push the plug connector on the
connection hose in to the pump water suction hood
corresponding aperture as far as it will go. Take care to
ensure that the hose is not kinked and that the end of the
hose with the strainer is positioned at the bottom of the
tank. Spray extraction liquid. Remove the screw plug from
the tank and pour in the mixture of water and concentrated
cleaning agent with the aid of the funnel. The capacity of
the tank is 4.5 liters.
Preparation for Spray
Extraction
CAUTION!
Use only non-polluting, environment-friendly cleaning
agents. Please observe the mixture ratio specified by
the manufacturer.
