Faittoo FT-AVR2204H, Manual

Page: 26 / 64

HD Hybrid 5 in 1 DVR Manual V1.1 http://www.faittoo.com sevice@faittoo.com
26
2) Adjust three states: Default , bright , soft, as shown:
Figure 4-21
Illustration
●
setup a channel parameter is completed, can be set via a button " Copy to " all channels
●
If only one channel is set , double-click into the channel, right mouse click to select "Channel
adjustment ". Click "Channel adjust" is defaulted into the first passage
4.11 Channel mode( Refer to 4.4)
4.12 PTZ Control
PTZ control supports two modes:
RS485
and
UTC coaxial control
4.12.1 RS485 Mode
Firstly connect the PTZ CAMERA and DVR's RS485 port through the wire, please just keep positive-to-
positive pole and negative-to-negative pole (Noted the postive and negative poles can not be reversed).
Then set the PTZ CAMERA and DVR with same Protocol, Baud rate, Address code.
For example, PTZ CAMERA Protocol is “Pelco-D”, Baud rate is “2400”, Address code is “1”, and connect
this PTZ CAMERA to DVR's Channel 1, the DVR setting will be shown as below:
Right- click into the "System Setup" - > "Channel Setup" - > " PTZ Setup"
Figure 4-22
Then click “?” into the PTZ control interface
，
refer to 4.12.3.
4.12.2 UTC coaxial control
In UTC coaxial control mode, PTZ camera must support UTC function, the camera through the coaxial
cable connected to the DVR VIDEO IN, and set it in these ways, as shown below:
Figure 4-23
Select UTC
Address code
Protocol
Baudrate
Select RS485 Select Channel 1