Faittoo FT-AVR2204H, Manual

Page: 23 / 64

HD Hybrid 5 in 1 DVR Manual V1.1 http://www.faittoo.com sevice@faittoo.com
23
Operation Procedure:
1) Right Main Menu " System Setup" - > " General Setup " -> " Screen Setup " to enter the interface, as
shown below :
Figure 4-17
2) Set the polling time(Auto switch time) , respectively, 2,3,4,5,8,10 seconds
3) After setup, check the " Auto Switch" is Enable, the mouse click ok
Illustration
●
" Auto switch " on automatic polling, select the screen switching time, the interface will start
switching channel page at the set time, there are two kinds of screen 1,4 switching mode
●
" Auto switch " such as checking the "Skip Video Loss " If there are no channels displayed on the
screen , the channel screen polling will automatically skip this screen
4.6 Electronic zoom
Operation Procedure:
1) Double-click any video channel on the main interface or on the preview or playback interface, you can
use an electronic zoom mode
2) Hold down the left mouse button to zoom in or out part of the area of the image
3) Double-click the left mouse button or middle mouse button to exit screen electronic amplification
Illustration
●
Double-click to enter video channel interface, to electronic amplification image
●
On the playback interface,Electronic zoom must be used when playing video, and is not
available when pausing playback
4.7 Main menu Introduction
Press the MENU button or the right mouse button to popup the main menu , the main menu consists of
the following three parts: