2) Lower Strut Tubes
3) Upper Strut Tube
1) Strut Tube Clamp
2
5) Rear Pivot Bolt
4) Leg Strut
ASSEMBLY OF
HIGH WALKERS STILTS
1) Loosen the
Strut Tube Clamp
(A)
on the side
of each stilt. Insert the tubes into and through
the lower tube clamps. Leave the tube clamps
loose, for now.
2) Attach the
Lower Strut Tubes (B)
to the rear
outer leg bracket with the attached 1/4” x
1/2” cap screw. Do not tighten these until the
assembly of the stilts is complete.
3) Slide the
Upper Strut Tube (C)
down over the
lower strut tube
(B)
and position it so that the
leg band fi ts just above the large portion of the
leg calves.
Note: Do not bend the leg bands (Calf
support).
4) Adjust the upper strut tube
(Leg Strut D)
until
a snug fi t on your calf is achieved and tighten
the strut tube clamp. The stilts should then
stand straight when fi tted and the calf straps are
tighten.
Tighten the tube clamps evenly, just enough to
prevent the upper strut tube from rotating, when
the stilts are in use.
Do not over tighten the strut tube clamps, as
this may cause the upper strut tube to become
deformed and require replacement.
5) Unscrew and adjust the heel bracket so that
the outside ankle bone is directly over the
Rear
Pivot Bolt (E).
Once you have fi nished assembling your
stilts please check that all the clamps,
screws and bolts have been fully tightened
before use. Please retain these instructions
for future reference.
A
B
C
D
E
B
