Charging the LED Work Light
The LED Work Light must be fully charged before being used for the first time.
This will ensure that the battery gives its best performance now and on future re-charging cycles.
The AC and DC charging adapters are for re-charging the battery only.
Using the AC Charging Adapter
1) Plug the charging cables jack plug into the
recharge socket of the Work Light. located
under the Black rubber cover
2) Plug the adapter into a 240V socket and
switch the socket on (if applicable).
3) The charging indicator lamp on the back panel
of the lamp will glow RED while charging is in
progress and then GREEN when fully charged.
4) The battery will be fully charged after
approximately 3 hours, disconnect the jack
plug from the Work Light, remove the adapter
from the wall socket or switch off.
Using the DC Charging Adapter
1) Plug the charging cables jack plug into the
recharge socket of the Work Light.
2) Plug the adapter into the vehicles 12V DC
cigarette lighter or accessory power socket.
3) The charging indicator lamp will glow RED
while charging is in progress and then turn
green when fully charged.
4) Disconnect the jack plug from the light, and
remove the DC adapter from the outlet socket.
5) The battery will be fully charged after
approximately 3.5 hours, Disconnect the jack
plug from the Work Light, remove the DC
adapter from the outlet socket.
To prevent overheating do not charge
for more than 9 hours.
Safety Precautions
The DC charging adapter can be used in most
vehicles by plugging into the 12V DC cigarette
lighter or accessory power socket.
Consult your vehicle owner’s manual for further
information on operating 12V DC accessories.
Do not drive the vehicle while charging, as an
unsecured light may be a hazard during certain
driving manoeuvres.
Store in dry location and do not allow the charging
adapter to come in contact with water, rain or snow.
If the charging adapter comes into contact with
water, place in a dry location at room temperature,
on a soft absorbent towel and allow to dry
thoroughly.
Do not operate the unit until it is completely
free of moisture.
If the adaptor becomes submerged in water,
discontinue use immediately and contact your local
Faithfull retailer for a replacement charging adapter.
Do not store charging adapter where temperatures
may exceed 122°F (50°C).
Use only the DC charging adapter supplied with
the light. Do not attempt to charge the light with an
adapter that is not compatible as this could result in
a fire, damage to the torch or personal injury.
Safety Precautions
Use 240V AC charging adapter indoors in a dry
location only. Exposure to damp or wet conditions
could cause electrocution or damage to adapter.
Do not use the charger in the vicinity of flammable
liquids or materials.
Do not use the charging adapter in combination with
any extension cord, electrical generators, or step-up
transformers.
Always plug the adapter directly into a 240V outlet in
a suitable location.
Store in dry location and do not allow the charging
adapter to come in contact with water, rain or snow.
If the charging adapter comes into contact with
water, place in a dry location at room temperature,
on a soft absorbent towel and allow to dry thoroughly.
Do not operate the unit until it is completely free of
moisture.
If the adaptor becomes submerged in water,
discontinue use immediately and contact your local
Faithfull retailer for a replacement charger unit.
Do not store charging adapter where temperatures
may exceed 122°F (50°C). Use only the AC
charging adapter supplied with the light.
Do not attempt to charge the light with an adapter that
is not compatible as this could result in a fire, damage
to the light or personal injury.
