M-PP193ws.doc
Issue 3226-Sep 01
Issue 3285 Oct 02
Issue 3415 Sept o4
Issue 3436 Jan 05
Issue 3523 Dec 05
10
On some base plates it will be necessary to mark out and drill the fixing holes. It is
recommended that the base plate is removed to make this easier. Place the base
plate the right way up onto the edge of the attachment plate abutting one of the studs
and with the sloping face of the base plate nesting in the sloping face of the
attachment plate. Mark the edge of the base plate where the front holes and studs in
the attachment plate come and use these marks to scribe underneath the base plate
the transverse centre lines of the holes to be drilled. Mark the front to back centre
line. Drill three 11mm diameter holes through the front sloping face, one on the
centre line and 205mm each side of the centre line and drill two 11mm diameter
holes 115mm each side of the centre line for the studs. Refit the base plate. Fit the
attachment plate with the fastenings provided.
Check tightness of fastenings after 15 minutes operation.
For Cast Base Plate
Place the compactor on the attachment plate and check that the holes in the
attachment plate line up with the slots in the base plate. Fasten attachment to base
plate with screws and washers provided. The large diameter washers with a flat are
fitted on the inside of the front and the fully rounded large diameter washers are fitted
at the rear.
Check tightness of fastenings after 15 minutes operation.
