8
3. Insert the blades (9) on to the motor shaft,
fixing them with the nut (10).
Check that the blades do not touch
anything when you turn them by hand.
The blades must turn freely, if not repeat
from step 2.
4. Assemble the front grille (11) and press
gently until it fits into the plastic ring.
5. Close the safety clip by tightening the nut.
Installing the wall fan (Fig. 3 and 4)
• The fan should be assembled in the most
accessible place for the plug socket.
• Using the wall support as a guide, make
marks for the drill holes. Then insert the
studs and adjust the support firmly with
the screws.
• Hang the fan on its support.
• The fan should not be installed at a height
under 2.3m.
5. OPERATING INSTRUCTIONS
• Put the selector (3) in the "0" position to
ensure that the fan is off and then plug it
in.
• Select one of the 1, 2 or 3 positions on
the selector (3) for your chosen speed.
• In order to stop the fan, turn the control
(3) to either of the "0" positions.
Speeds:
0 Off
1 Low
2 Medium
3 High
NOTE: you can also turn the selector (3) by
pulling the cord (5). (Fig. 5)
6. SWINGING
The swing control (1) is located on the
motor, at the back. For the fan to swing,
press the swing control. To stop the swing,
pull the control up. (Fig.6)
7. TILT
The fan can be directly up or down
manually (Fig.7)
10. INFORMATION FOR THE CORRECT
DISPOSAL OF ELECTRICAL AND
ELECTRONIC APPLIANCES
At the end of its working life, the
product must not be disposed of
as urban waste. It must be taken
to a special local authority
differentiated waste collection
centre or to a dealer providing this
service. Disposing of a household appliance
separately avoids possible negative consequences
for the environment and health deriving from
inappropriate disposal and enables the constituent
materials to be recovered to obtain significant
savings in energy and resources.
To remind you that you must collaborate with a
selective collection scheme, the symbol shown
appears on the product warning you not to dispose
of it in traditional refuse containers.
For further information, contact your local authority
or the shop where you bought the product.
9
. MAINTENANCE AND CLEANING
• Before cleaning, turn the selector (3) to the "0"
position and unplug the appliance.
• If you want to release the appliance for
cleaning, reverse the assembly instructions.
• DO NOT SUBMERGE IT IN WATER.
• Apply a few drops of lubricant on to the motor
shaft to avoid corrosion.
• The blades can be cleaned in warm water with
a little gentle neutral soap.
• They can also be cleaned with a slightly damp
soft cloth.
• The external part of the motor can be cleaned
with a slightly damp soft cloth.
• Do not use solvents or abrasive products to
clean the fan.
8. TIMER
If you want the fan to operate for a determined
time, turn the timer (4) clockwise positioning it on
the time of your choice. The maximum time which
you can select with the timer is 3 hours ("180").
For continuous operation turn the timer (4) to the
"CONT" position.
To disconnect the fan from the power, turn the
timer (4) to the "0" position.
interior 28/12/05 11:05 Página 7
