Fagor SFE-820CEA, Instruction Book

Page: 34 / 116

The stacking kit shall be one of that
above, obtainable from our spare
service.
The instructions for installati
on and any fixing attachments, are
provided with the staking kit.
Ventilation
Do not install the product in a
low temperature room or in a room
where there is a risk of frost
occurring. At temperature around
freezing point the product may not
be able to operate properly: there
is a risk of damage if the water is
allowed to freeze in the hydraulic
circuit (valves, hoses, pumps). For
a better product performance the
ambient room temperature must
be b2°C and +35°C.
Please note that operating in cold
condition (b2 and +15°C)
might simply some water
condensation and water drops on
floor.
INTRODUCTION
SAFETY REMINDERS
ٴ
Adequate ventilation must be
provided in the room where the
tumble dryer is located to prevent
gases from appliances burning
other fuels, including open fires,
being drawn into the room during
operation of the tumble dryer.
ٴ
Installing the rear of the
appliance close to a wall or vertical
surface.
ٴ
There should be a gap of at least
12 mm between the machine and
any obstrubtions.The inlet and outlet
s h o u l d b e k e p t c l e a r o f
obstruction.To ensure adequate
ventilation the space between the
bottom of the machine and the floor
must not be obstructed.
ٴ
Check regularly that the air flowing
through the dryer is not restricted.
ٴ
Check frequently the fluff filter after
use, and clean, if necessary.
ٴ
Prevent items from falling or
collecting behind the dryer as these
may obstruct the air inlet and outlet
ٴ
NEVER install the dryer up against
curtains.
ٴ
In cases where the dryer is
installed on top of a washing
machine, a suitable stacking kit must
be used according to the follow
configuration.
-Stacking kit Mod 35100019: for
minimum washing machine depth
49 cm
-Stacking kit Mod 35900120: for
minimum washing machine depth
51 cm
EN 34