13
Refrigerator Leveling &
Door Adjustment
The refrigerator must be leve
led
in order to maintain optimal
performance and desirable front appearance.
(
You will be able to tell the refrigerator is uneven because
the freezer and refrigerator doors look unbalanced.
In case freezer door is lower than
refrigerator door...
Insert a screw driver (flat tip)
into a groove of the left wheel
(bottom of freezer) and turn
it clockwise until the door is
balanced. (clockwise to raise
freezer door; counterclockwise
to lower)
Ɠ
If the freezer door is not balanced by step 1, then
follow the next steps.
Open the doors, unscrew the
front cover and remove, if it is
attached.
.
In case refrigerator door is lower than
freezer door...
Insert a screw driver (flat tip)
into a groove of the right wheel
(bottom of refrigerator) and
turn it clockwise until the door
is balanced. (clockwise to raise
refrigerator door ;
counterclockwise to lower)
Ɠ
If the refrigerator door is not balanced by step 1, then
follow the next steps.
Insert a spanner (A part) into the hinge nut (1 part) and
unscrew the nut by turning clockwise.
Insert a spanner (B part) into the hinge nut (2 part) and
turn counter-clockwise to highten the door.
Front Cover
After installation and/or door leveling, fasten front cover with
screws. (Remove the screws on the front bottom panel first.
Click and screw the cover)
Caution
Ɨ
The front of refrigerator needs to be just a little
higher than the back for easy door closing
. However,
if
the wheel is raised too much for door balance,
i.e. the front of refrigerator is much higher than
the back, it can be difficult to open the door.
Water filter
(
Dispenser models only)
1. Remove the locking cap for
in
s
talling the filter.
(The ice and water dispenser can
also be used without a water filter,
in which case the locking cap must
be used. )
2. Carefully turn the filter clockwise.
3. Change the filter at least every
6
months.
ٙ$1HZILOWHUFDQEHREWDLQHGIURP
an authorized aftersales
service.
Caution
Ɨ
Make sure to clean up any fallen water during the
filter installation.
1
1
2
3
2
4
3
If the door is aligned, fasten the nut (1) tightly with
turning.
Insert a spanner
(Part A)
into the hinge nut(1part) and
unscrew the nut by turning clockwise.
Insert a spanner (B part) into the hinge nut(2part)
and turn clockwise to lower the door
If the door is aligned, fasten the nut (1) tightly by turning
counter-clockwise.
4
5
