Fagor NVR-4603 6P 12C, Instruction Manual

Page: 39 / 89

The water softener must be set manually, using the water hardness dial.
The water softener is designed to remove minerals and salts from the water, which would have
a detrimental or adverse effect on the operation of the appliance.
The higher the content of these minerals and salts, the harder your water is.
The softener should be adjusted according to the hardness of the water in your area. Your local Water Authority
can advise you on the hardness of the water in your area.
WATER SOFTENER
The hardness of the water varies from place to place. If hard water is used in the dishwasher, deposits will
form on the dishes and utensils.
The appliance is equipped with a special softener that uses a salt container specifically designed to eliminate
lime and minerals from the water.
If your model does not have any water softener, you may skip this section.
Before using your dishwasher for the first time:
A. Set the water softener
B. Add 1.5Kg dishwasher salt and then full fill the salt container with water
C. Fill the rinse aid dispenser
D. Fill in detergent
Contact your local water board for information on the hardness of your water supply.
Clark: British degree
fH: French degree
dH: German degree
dH=1.25 Clarke=1.78 fH=0.178mmol/l 1
The manufactory setting: (EN 50242)
Adjusting Salt Consumption
dH mmol/l
0~9 0~5 0~0.94 H1--9h Light bright 0
10-20 6-11 1.0-2.0 H2--6h Light bright 9
21-30 12-17 2.1-3.0 H3--6h 9h Light bright
、
12
H4--3h Light bright
20
fH
0~6
7-14
15-21
Clarke
WATER HARDNESS
Selector Position
Salt consumption
(gram/cycle)
Please follow the steps below for adjustment in salt consumption.
18-22 31-40 22-28 3.1-4.0
41-60 23-34 4.1-6.0 H5--3h 9h Light bright
、
30
H6--3h 6h Light bright
、
60
29-42
1. Close the door ,switch on the appliance;
2. Press the Start/Pause button for more than 5 seconds to start the water softener
set model within 60seconds after the appliance was switched on( The Salt and
Rinse aid warning lights will be on periodically when it get in the set model );
3. Press the Start/Pause button to select the proper set according to
your local environment, the sets will change in the following
sequence: H1->H2->H3->H4->H5->H6;
4. Press the On/Off button or no operation for 5 seconds to end the set up model.
35-55 61-98 43-69 6.1-9.8