Fagor FA-5812, Care & Instruction Manual

Page: 28 / 88

safety and troubleshooting
28
When the display shows the message “ Not
draining water! ” for 4 seconds, and the
following messages appear at 2-second
intervals:
Has the filter been drained?
Home drain?
Causes for the display may be: the
machine’s drain motor pump or the
building’s drain pipe are blocked, or the
motor pump is not properly connected.
Procedure: if the cause is found to be a
blocked motor pump, proceed according
to section 2, maintenance and cleaning.
When water is not loading, the display
shows the message “
Not loading water! ”
for 4 seconds, and the following messages
appear at 2-second intervals:
Is the faucet
turned off? Has the water been cut off?
Water filter?
The reason for water not loading may be
that the water service has been cut off, the
water intake faucet to the machine is
closed, or the water intake filter to the
machine is blocked.
Therefore, you could take one of the
following measures: wait until the water
service has returned, open the water intake
faucet, and release the water intake hose
to clean its filter.
Why is the machine not loading water?
Why is the washing machine not
draining water or spinning?
Why are clothes wetter than usual?
The display shows the message “ Clothes
too wet! ” for 4 seconds, and the following
messages appear at 2-second intervals:
Run cycle 15.
This is caused by an uneven distribution
of clothes inside the drum, which has
triggered a safety device that prevents the
washing machine from spinning at the
maximum number of revolutions. This
prevents the machine from vibrating
excessively and, therefore, provides greater
reliability.
Not loading water!
Is the faucet turned off?
Not draining water!
FILTRO VACIADO?
Clothes too wet!
Run cycle 15
Not draining water!
Has the filter been drained?