Fagor DDS APS-24, Hardware Manual

Page: 249 / 406

   Cables
7.
Ref.1912
· 249 ·
DDS
HARDWARE
7.6 Signal cables for control and communications
Encoder simulator from the drive to the CNC
Depending on motor feedback, the drive can generate a set of signals that
simulate those of a differential TTL encoder attached to the rotor of the
motor. The attached tables show this cable supplied by FAGOR to connect
the drive (X3) and the CNC 8055 (X1, X2, X3 or X4) / 8055i (X10, X11, X12
or X13) / 8065/8070 (LOCAL COUNTER 1/2). The attached tables show
this cable supplied by FAGOR to connect the drive and the CNC
.
They are
supplied with connectors at both ends and their sales model is:
SEC-HD-

cable
T. H7/16 Range of SEC-HD-  cables. The number indicates their length
in meters including the connectors.
SEC-HD-1 SEC-HD-10 SEC-HD-25
SEC-HD-3 SEC-HD-15 SEC-HD-30
SEC-HD-5 SEC-HD-20 SEC-HD-35
F. H7/6
Connection of the cable for the encoder simulation and the CNC.
Yellow
Purple
Blue
Grey
Green
Brown
Pink
Black
White
Ready Made Cable SEC-HD-1/3/5/10/15/20/25/30/35
Length in meters; including connectors
6
5
4
3
2
1
7
8
Cable 2x4x0.14+1x2x0.5
11
Pin
Twisted pair. Overall shield. Metallic shield connected to CHASSIS pin
(at the CNC end and at the Drive end)
6
5
4
3
2
1
7
8
11
Pin
Io
B
A
GND
Signal
CHASSIS
1
5
(HD,
Sub-D,
F15)
Front View
11
15
to DRIVE -X3-
1
5
(HD,
Sub-D,
M15)
Front View
15
11
A
B
Io
AL
AL
to CNC
INFORMATION. The maximum length for SEC-HD-  cables for best
performance is 50 meters.
i