Fagor CNC 8070, Programming Manual

Page: 272 / 556

‡ ‡ ‡ ‡ ‡ ‡ ‡ ‡ ‡ ‡ ‡ ‡
Programming manual
326
CNC 8070
12.
CYCLE EDI
T
OR
G
e
n
e
ra
l conc
ept
s
(S
OFT
V02.0
X
)
238
If it has a multiple machining associated to it, the tool moves in XY,
along the safety plane (Zs), up to the next point to be machined.
The approach plane permits, as in the case of the figure, a fast
approach to the machining surface when the safety plane (Zs) is far
away from the part surface.
12.1.3 Selecting data, profiles and icons
Data selection.
To enter or modify a data, it must be selected; i.e. it must have the
editing focus on it.
The parameters of the cycles may be selected with the [
§
] [
¨
] [
©
]
[
ª
] keys or with the direct access keys. The first data of each group
may also be selected by pressing the page-up and page-down keys.
The direct access keys correspond to the name of the parameters; [F]
for feedrates, [T] for tools, etc. Every time the same key is pressed,
it selects the next data of the same type.
Data entry.
Place the cursor in the relevant window, key in the desired value and
press [ENTER]. If [ENTER] is not pressed, the new value will not be
assumed.
If the Teach-in mode is selected, the current position of the machine
may be associated with a coordinate. Place the cursor in the relevant
window and press the [RECALL] key.
For the X axis parameters, it will take the coordinate of the first axis
of the channel where the edit-simulation mode is active. For the Y axis
parameters, the coordinate of the second axis and for the Z axis
parameters, the coordinate of the third one.
Changing the state of an icon.
Place the cursor on the desired icon and press the space bar.