67
Problems
Possible causes
Remedies
Temperature inside the appli-
ance is not low enough or too
high
Incorrect setting of the adjust-
ment knob
- reset the knob to a higher
position
The ambient temperature is
higher or lower than the climate
range from table with technical
specification
- the appliance is adapted to op-
eration in the climate range from
table with technical specification.
The appliance is located in a
sunlit place or near heat sources
- move the appliance to another
place. Observe the guidelines
contained in the manual
Too much warm food loaded at
a time
- wait 72 hours until the food
becomes cool (freezes) and the
required temperature is reached
inside the chamber
Internal air circulation obstructed
- place the food and containers
in such a way that they do not
touch the rear wall of the fridge
The air circulation at the back of
the appliance is obstructed
- move the appliance min. 30
mm away from the wall
The door of the fridge/freezer is
opened too often and/or remains
open for too long
- reduce the frequency of open-
ing the door and/or shorten the
time when door remains open
The door does not close com-
pletely
- place the food and containers
so that they would not interfere
with door closed
The compressor is switched on
too rarely
- check whether the ambient
temperature is not lower than
climate class
Door gasket inserted incorrectly - press the gasket in
Certain sounds can be heard during normal use of the refrigerator, which do not
affect its correct operation.
Sounds, which can be easily prevented:
• noise caused by the appliance which is not level - adjust the position with the ad-
justable turn-in front feet. Alternatively, place pads made of soft material under
the rear rollers, especially when the appliance is placed on tiles.
• touching the adjacent piece of furniture - move the refrigerator away.
• creaking of the drawers or shelves - take out and put back the drawer or shelf.
• sounds of clinking bottles - move bottles apart.
Sounds heard during normal use are mainly due to operation of the thermostat, com-
pressor (switching on) and cooling system (thermal expansion and contraction of the
radiator caused by flow of the cooling agent).
Summary of Contents for 3FIS-840
