41
Remote control
Your kitchen hood is equipped with a remote control. It is shown in Figure 4a and
below:
8
7
10
9
Use remote control to control your kitchen hood. To do this, point the remote control
toward the front of the hood and select the appropriate function:
7-
Reduce fan speed
8-
Increase fan speed
9-
Turn lighting on/off
10-
Standby mode on/off
When purchased, battery is not included with the remote control. You can purchase
a single 3V CR2025 battery in any electronics store.
To replace the battery, slide out the tray (item 3 in the figure) on the bottom edge
of the remote control. Place the battery in the tray observing polarity. Slide the tray
back in.
Important!
Ensure there are no obstacles between the remote control transmitter
and the sensor on the cooker hood. Fluorescent light can interfere with the remote
control operation.
Indication to clean the aluminium filters
If the
indication appears on the display, you need to clean the aluminium filters.
Once the filters are cleaned you can clear the
indication. Touch and hold for
approximately 3 seconds to do this. The symbol will be shown on the display and
the appliance will operate normally.
Note:
To clear the indication, the appliance must not operate.
If you want to continue to use the appliance while the indication is not cleared,
touch and fan speed will be displayed temporarily and then will be displayed
again. The fan will continue to operate.
Note:
The indication will be displayed after approximately 60 hours of fan opera-
tion.
Summary of Contents for 3CFB-9000IX
Page 2: ...2 ...
Page 49: ...49 ...
Page 50: ...50 h h h 650mm h 650mm h h h 650mm h 450mm 1 ...
