Fagerhult 86370, User Manual, Page: 8 / 23

8
Shift
ON
OFF AUTO MODE
DEFAULT
Start
LOW MID
Save
Apply
10% 50% 75%
POWER
100%
POWER
80%
100%
Disable
20 min
HIGH
MANUAL ON MODE
MANUAL SETTING
10 min 1 min
Test
2 S
30 min 15 min 5 min 30 s
1 min
20% 30% 50% 10%
10 min
RX
STBY%
MW/PIR
RX
100%
MW+PIR
Send
PIR
Learn/
Erase
MW
5 min 10 s 30 min 1 h
Delay Time
Brightness
Standby Time
Standby Dimming Level
Dual Sensor Tech. & RF Mode
Detection Range Microwave Sensor
Daylight Threshold
Scene prog.
Shift
ON
OFF
AUTO MODE
DEFAULT
Start
LOW MID
Save
Apply
10% 50% 75%
POWER
100%
POWER
80%
100%
Disable
20 min
HIGH
MANUAL ON MODE
MANUAL SETTING
10 min 1 min
Test
2 S
30 min 15 min 5 min 30 s
1 min
20% 30% 50% 10%
10 min
RX
STBY%
MW/PIR
RX
100%
MW+PIR
Send
PIR
Learn/
Erase
MW
5 min 10 s 30 min 1 h
Delay Time
Brightness
Standby Time
Standby Dimming Level
Dual Sensor Tech. & RF Mode
Detection Range Microwave Sensor
Daylight Threshold
Scene prog.
Subject to change without notice. Version1_20180621
Simple programming functions
Sensors 86370 and 86371 can be programmed remotely
using a remote control without needing to set any fun-
ction in the sensor. This makes it easy to perform quick
changes in all functions.
The following pages describe the different procedures to
complete an installation.
Certain functions on the remote control have no function
in this system, and cannot affect the end result of the
programming.
A difference between 86370 and 86371 is that 86371 indi -
cates with a flashing light source when a signal is received
from the remote control. This is due to installation at a
high height. 86370 has an integrated red LED that indica-
tes the same thing.
Programming with remote control 86368
On delivery, the sensor has a standard setting that is also
very easy to use as start for the installation. The default
settings are:
Delay time: 5 min.
Standby time: 5 min.
Standby dimming level: 10%
Daylight Threshold: Disabled
Sensor active: PIR and Microwave
Regardless of which settings are made, it is always easy to
reset the presets using the DEFAULT button.
On delivery the rotary switch on the sensor is set to 0
which gives the settings above. If the switch is changed to
another position, that will be the standard setting.
Default setting of the sensor