background image

 

14

 
SYSTEM SPECIFICATIONS 

 
 

ROOF MOUNTING SPACE: 

Width = [Number of panels X 50.875 in. (129 cm)] + 24 in. (61 cm) 

 

Length = Panel  24 in. (61 cm) 

 

RACK SPACE: 

Width =  [Number of panels X 50.875 in. (129 cm)]+ 2 in. (5 cm) 

 

Length = Panel  6 in. (15 cm) 

 

FLOW: 

Maximum recommended flow = 8 gpm per panel 

 

 

3.47 psi head loss (1,817 I/hr, 0.244 kg/cm

2

 

Minimum recommended flow = 3 gpm per panel 

 

 

0.48 psi head loss (681 I/hr, 0.034 kg/cm

2

 

Recommended flow = 4 gpm per panel 

 

 

0.87 psi head loss (908 I/hr, 0.061 kg/cm

2

 
 

PANELS PER BANK: 

12 panels single end feed 

     (maximum) 

17 panels diagonal feed 

 
 

PRESSURE: 

NORMAL OPERATING                      MAXIMUM INTERMITTENT 

                                                                PRESSURE                                               PRESSURE

 

     80

o

F (27

o

C) 

         0 to 30 psi                                                     45 psi 

      

     (0 - 2.2 kg/cm

2

)                                            (3.21 kg/cm

2

 
     212

o

F (100

o

C) 

          0 to 5 psi                                                        5 psi 

      

    (0 - 0.35 kg/cm

2

)                                           (0.35 kg/cm

2

 
     70

o

F (21

o

C) 

Measured burst pressure of panel body = Over 300 psi (21.0 kg/cm

2

 
 

TEMPERATURE: 

Normal operating temperature = 60

o

F to 90

o

F (16

o

C to 32

o

C) 

 

Maximum continuous operating temperature = 212

o

F (100

o

C) 

 

Maximum intermittent temperature (unpressured) = 250

o

F (121

o

C) 

 

Melt temperature = 338

o

F (170

o

C) 

 
 

WEIGHT: 

Without Water:                                      

 

 

4 ft. X   8 ft. 

12.2 lbs (4.54 kg) or 0.38 lbs/ft

2

 (1.85 kg/m

2

 

 

4 ft. X 10 ft. 

14.3 lbs (5.34 kg) or 0.36 lbs/ft

2

 (1.76 kg/m

2

 

 

4 ft. X 12 ft. 

16.47 lbs (6.15 kg) or 0.34 lbs/ft

2

 (1.67 kg/m

2

)

 

 

With Water: 

 

 

4 ft. X   8 ft. 

46 lbs (17.2 kg) or 1.44 lbs/ft

2

 (7.03 kg/m

2

 

 

4 ft. X 10 ft. 

53.8 lbs 20.1kg) or 1.35 lbs/ft

2

 (6.59 kg/m

2

 

 

4 ft. X 12 ft. 

61.7 lbs (23.07 kg) or 1.29 lbs/ft

2

 (6.28 kg/m

2

 
All specifications and dimensions set forth above are as estimated by FAFCO Inc., but are not intended to be precise and should not be relied 
upon as precise without independent verification.  These estimated specifications and dimensions are subject to change without notice.  
Nothing contained herein is intended or should be construed to expand or extend FAFCO Inc.'s warranty, or establish any express or implied 
warranties of any nature, other than as contained in the Twelve Year Warranty Agreement.  (FAFCO Inc. disclaims any other warranties and 
assumes no duty to provide notice if it becomes aware of any deficiencies in these estimates.)  The reader accepts full responsibility for any 
use or application of these estimates and specifically understands and acknowledges the limited reliability of these estimates. 

 
FAFCO, Inc.

 

435 Otterson Drive 
Chico, CA  95928 
Phone: (530)  332-2100 
FAX:  (530) 332-2109 
Part #  06957 REV A 
10/06  

Summary of Contents for ST















Reviews: