38
Step 8: Mount Collectors
Step 7: Lay corrugated sheet
Step 9: Mount Expansion Reservoir
Lay collectors on
substrate with top
headers hanging
over substrate.
Install and adjust
header straps so
that top headers
remain hanging
over and touch-
ing the end of the sheet. Install the body straps.
When installing additional collectors, the additional
channel ends should be aligned flush against the
others.
A. Lay two pieces
of the corru-
gated sheet on
the channels
with overlapped
ends. Adjust to
a total length of
94” for 8’ col-
lectors or 142”
for 12’ collectors and secure together with a
#6 screw. Slide sheet until the ends hang over
equally above and below the channels.
B. Center sheet equally side–to-side between the
bases. Drive a #6 screw into the channels at
every other valley. Clean away all metal shav-
ings.
Place reservoir on
channel above chosen
outlet collector header,
centered between
header straps as
shown. Mark and drill
pilot holes with 3/16”
drill bit. Mount reser-
voir to channel with two #14 x 2-1/2”, self tapping,
stainless steel screws with fender washers. These
are not provided.
Note: Snug down only, do not over tighten.
Tile Roof Installation Kit (TRIK)
Step-by-Step Installation
Summary of Contents for 500 Series
Page 28: ...27 Required Labels...
