32
Step 5: Seal And Secure Angle
Step 6: Place Lower Angle Mount
Step 8: Secure PV Panel To Angles
Step 7: Secure Lower Angle Mount
Step 9: Connect PV Wire To Panel
Step 10: Connect PV Wire To ICM
Tile Roof Installation (Continued)
Place a nickel size
daub of roof seal-
ant at each hole.
Replace angle and
secure to tiles with
two 1/4” x 1-1/4”
concrete screws.
Hold lower angle
mount in place
against lower end
of panel and lay
panel in place
against upper
angle mount.
Lay panel inside an-
gles with wire protrud-
ing toward upper roof
jack. Attach with (4)
#14 x 1” self-tapping
screws.
Repeat procedure for
lower angle mount.
Run PV panel wires
alongside roof sensor
wire under roof jack
into attic. Run 50’ PV
wire from ICM, along-
side sensor wire, and
connect to PV panel
wire in attic with wire nuts.
Connect positive to
positive and negative to negative.
Connect the 50’ PV
wire to the controller
terminal block.
Con-
nect positive to posi-
tive and negative to
negative.
PV Panel Kit
Summary of Contents for 500 Series
Page 28: ...27 Required Labels...
