Bench base fix detail
475
2
3
0
45
0
Ground
level
1800 (Ctrs)
185 (Ctrs)
2300
250
250
450
*
230
75
75
Recommended plinth size
2300x400x390mm
(C20 concrete or similar)
450
*
100
185
115
Recommended plinth size
2300x400x390mm
(C20 concrete or similar)
100
185
115
M10x125mm
resin fix
anchor insert
M10x125mm
resin fix
anchor insert
Ø25
150
Ø25
150
475
M10 x 30mm
button head bolt
M10 x 30mm
button head bolt
230
595
Seat base fix detail
Installation Instructions
ALL INSTALLATION WORKS TO BE CARRIED OUT BY COMPETENT PERSONNEL - INSTALL AS COMPLETE UNIT
Tord Wall Bench (same fixing centres for seat)
Tord Wall Bench / Seat
1. Install suitable plinth / wall
(see illustration for recommended minimum plinth dimensions)
2. Screw
stainless steel resin anchor inserts onto concealed M10 x 30mm bolts protruding through frame.
Anchors should be finger tight.
(4 anchors per bench / seat).
3. Place bench / seat in desired position on plinth / wall
(balanced on anchor inserts)
. Carefully mark around
anchors to obtain hole positions
4. Remove bench / seat; drill holes 25 dia. x 150mm deep; clear debris from holes.
5. Ensure at this stage that anchors bolts are loosened - allow about 2mm play to allow for final tightening once
the resin has cured.
6. Fill the holes in the plinth / wall to within approximately 50mm from the top with Hilti HY150 resin (or similar).
7. Lift the bench / seat (with resin anchors in place) and carefully lower the anchors into the holes, leave for two
hours before tightening
(or as per manufacturer’s instructions).
8. Once resin has cured
:
tighten anchor bolts to securely fasten down bench / seat.
(Concealed anchor bolts
are accessible for final tightening through the gaps between the slats.)
9. Check level
4
TORD WALL
installation
