factoryfurniture.co.uk
Installation Instructions
All installation works to be carried out by competent
personnel - install as complete unit.
Murton Table & Picnic Table
1.
Install suitable foundation pads (see illustration)
each with top face at ground level
2.
Position table in correct orientation with bases
centrally on foundation pads, then mark hole
positions through base plates.
3.
Remove the table; drill holes Ø14mm x 220mm
deep
4.
Clear debris from holes.
5.
Fill the holes to within approximately 35mm from the
top with Hilti HY150 resin (or similar). Lift the table
(with threaded anchor rods/capnuts in place) and
carefully lower the anchors into the holes, leave for
two hours before using.
6.
Using a torque wrench, tighten nuts and washers
over flange plates to 30Nm to fasten down the table.
7.
Check level
IMPORTANT NOTE
Ensure that stainless steel is protected during site
cutting of stone – contamination from disc cutters will
produce corrosion on stainless steel components.
2020
72
0
1920 (Fixing Ctrs)
Foundation 2 no. pads
400x300x1000mm in
C20 concrete
(recommendation only)
Ground level
600 (Fixing Ctrs)
1650
825
45
0
2020
72
0
1920 (Fixing Ctrs)
Foundation 2 no. pads
400x300x1000mm in
C20 concrete
(recommendation only)
Ground level
600 (Fixing Ctrs)
825
825
Table
Picnic Table
22
0
200mm x M10
threaded rod
anchor resin fixed
into Ø14mm hole
M10 S/S
cap nut
18
400 x 300 x 1000mm
C20 Concrete Base
(recommended)
Ground level
