1895 Ctrs
450
300 Ctrs
450
100
Foundation 2 no. pads 400 x
400 x 400mm in C20 concrete
(recommendation only)
1950
300 Ctrs
Ground Level
430
430
450
3
25
1760
1895 Ctrs
300 Ctrs
Foundation 2 no. pads 400 x
400 x 400mm in C20 concrete
(recommendation only)
Ground Level
450
3
25
300 Ctrs
1
00
470
470
2050
Foundation -
400x400x400mm
concrete block
(recommended)
75
12
M10 x 75mm
sleeve anchor
into 12mm hole
in foundation
with anti-vandal
armour ring
Ground Level
75
12
M10 x 75mm
sleeve anchor
into 12mm hole
in foundation
Ground Level
Installation Instructions
ALL INSTALLATION WORKS TO BE CARRIED OUT BY COMPETENT PERSONNEL - INSTALL AS COMPLETE UNIT
Bench surface / sub-surface fix
Seat surface / sub-surface fix
Bloc Bench / Seat (Steel)
(surface & sub-surface fix)
1. Install suitable foundation pads (see illustration) each with top face at ground level or 100mm below finished
ground level for sub-surface fix
2. Position bench / seat in correct orientation, with base centrally on foundation pads, then mark hole positions
through fixing lugs.
3. Remove the bench / seat; drill holes Ø12mm x 75mm deep (or as bolt manufacturer’s recommendations).
4. Clear debris from holes.
5. Reposition bench / seat unit and fix to foundation pads using 4 no. zinc-coated M10 x 75mm sleeve anchors
tightened to 50Nm (or as per manufacturer’s instruction). Ensure bench / seat remains level during fixing
process. For surface fix, hammer an anti-vandal armour ring over each bolt head to prevent tampering.
6. Check level & re-instate ground level if necessary (sub-surface fix).
IMPORTANT NOTE:
Ensure that stainless steel is protected during site cutting of stone – contamination from disc cutters will
produce corrosion on stainless steel components.
4
BLOC (steel) installation