PRE- SWEEPING CHECK LIST
READ AND UNDERSTAND SAFETY INSTURCTIONS ON PAGE 5 AND 6
BEFOR OPERATING THIS MACHINE
2. CHECK CONDITION OF MAIN BROOM
AND MAKE SURE IT IS SECURLY IN PLACE.
3. REMOVE ALL STRING BANDING, OR
ANYTHING WOUND AROUND THE IDLER
PULLEY AND BEARING.
(SEE FIGURE 16.)
PAGE 11
1. CHECK BATTERY CONDITION ON BATTERY
CONDITION METER. MAKE SURE BATTERIES ARE
FULLY CHARGED BEFORE USING.
(SEE FIGURE 15.)
4. CHECK CONDITION OF SIDE BROOMS
AND MAKE SURE THEY LIFTS AND LOWER
CORRECTLY.
5. CHECK THE SIDE BROOMS TO SEE IF THEY
ARE AT THE CORRECT SETTING FOR
SWEEPING.
(SEE FIGURE 17.)
6. CLEAN THE FILTER BY PRESSING THE
SHAKER SWITCH FOR ABOUT 10 SECONDS.
(SEE FIGURE 18.)
7. PRESS THE HOPPER LATCH, ON THE LEFT
SIDE OF THE MACHINE. REMOVE THE
HOPPER FROM THE MACHINE.
(SEE FIGURE 19.)
8. EMPTY THE HOPPER INTO A TRASH RECEPTICLE.
9. INSTALL THE HOPPER BACK INTO THE MACHINE
AND DEPRESS THE HOPPER LATCH.
(SEE FIGURE 20.)
(FIGURE 15.)
(FIGURE 18.)
(FIGURE 16.)
(FIGURE 19.)
(FIGURE 17.)
(FIGURE 20.)
