7
www.factorelectronics.com
RX (Receiver)
①
Optical audio input
– TOSLINK audio input. Connects to the Optical output of the local
display device for the Audio return channel ARC feature.
②
HDMI output
– Connect to the HDMI display HDMI input.
③
HDMI output LED indicator -- Lit if the HDMI output is active.
④
L/R output port
– 3.5mm stereo phone jack, extracts the audio from HDMI output.
Connected to an AV Receiver
⑤
Coaxial output port -- S/PDIF audio out, extracts the audio from HDMI output. Connected
to an AV Receiver.
⑥
Ethernet port --- RJ45 connector. Connect to your smart TV to extend the 10/100 network
through the HDBaseT Receiver Ethernet port. Note: TX must be connected to the router
or Ethernet switch.
⑦
Power port
– Use the included 24V/1A DC adapter to power the unit
⑧
Power LED indicator
– Lit when the unit is powered on successfully.
⑨
IR out port
–3.5mm mono phone-jack, connect to IR receiver cable
⑩
IR in port
–3.5mm stereo phone-jack, connect to IR emitter cable
⑪
Mode DIP Switch
– To switch RS-232 serial port between pass-through and firmware
upgrade mode, set as per below:
00: RS232 pass through
01: Valens firmware upgrade
10: MCU firmware upgrade
11: MCU firmware upgrade & Valens firmware upgrade
⑫
RS232 port
–DB9 female connector, connect to a DTE or DCE.
⑬
HDBT input
– RJ45 connector, connect to HDBT output port from the Transmitter.
⑭
Normal/ Long Cable selection switch
– Switch to left/right side to select Normal mode/ or
Long Reach mode. When set to Long Cable mode, the selection switch on TX Transmitter
should also be set to Long Cable Mode.
