27
Oil (67 28371)
REQUIREMENT
- THE AIR SHOULD HAVE A MAXIMUM OIL CONTENT OF 0.5 MG/M³
AND SHOULD BE WITHOUT SIGNIFICANT ODOUR OR TASTE.
Ensure the oil tube is kept vertical throughout this process.
Satisfactory test: - The white crystals will turn translucent and show at worst a slight discoloration.
Failed test:
- (Mineral oil) - The white crystals will show a light brown or darker
discoloration.
- (Synthetic oil) - The white crystals will show a yellow discoloration [Note: best
seen by comparing with an unused tube].
1. Using the Tube Tip Cutter,
place the ampoule section in
the platform at the bottom.
Note: Make sure the tube is
against the back wall of the
cutter. Line up the black dot
nearest the end of the tube with
dot on the cutter.
2. With one hand holding the
cutter, the other holding the
tube and with your thumb
against the base of the cutter,
apply pressure to the tube, this
should break the inner tube.
3.
Place
your
used
detector tubes in the
F2154 Travel Container,
until they can be disposed
of properly as “sharps” or
glass.
Summary of Contents for F4500
