7
OPERATING MANUAL AIR TOOL | RANDOM ORBIT SANDER (VACUUM TYPE) MODEL: 6313-D
GENERAL SAFETY:
G.
GENERAL COMMENTS.
Do not use tools for purposes other than those for which they were intended.
Air tools are not intended for use in potentially explosive atmospheres and are not protected by insulation
resistant to high voltage.
Care must be taken to prepare all possible precautions, both tools and jobs.
Keep tools clean and tidy and can fit for use.
In areas exposed to mechanical damage, use reinforced hose.
Connecting and disconnecting the hose from the main line should be at the air valve is closed.
After connecting the hose to blow him first, while maintaining the necessary precautions to remove accumulated
dust in it, and then connect the pneumatic tool.
Hoses should not breed with energized electrical conductors or be in the vicinity.
H.
BEFORE YOU BEGIN
Dress in protective clothing and use referred to in the workplace. Do not use loose clothing that movable tool
during operation causes a risk of ignition or the inclusion of the material in the mechanism of the tool.
Before each use, visually inspect tools, their technical condition.
NOTE! If you notice any damage or defects must not undertake work. You should immediately notify your
immediate supervisor for quick disposal. Only after confirming that they were removed employee may proceed to
carry out the task.
Make sure pressure hoses are not damaged or loose.
Make sure that the work will not begin hazards for people residing in the workplace or in its immediate vicinity.
Starting to work to gradually bring the air to the tool, and after finding his fitness to enable full air flow. In case of
irregularities in its operation, immediately shut off the air.
I.
DURING OPERATION.
Working side by side set up so that no one has been exposed to trauma caused by tool neighbor.
It is so secure the working tip of the tool in the holder to prevent them from falling out during operation.
Disconnect tool from air hose when not in use, before changing accessories, change the settings or repair.
J.
IT IS UNACCEPTABLE:
Exceeding the maximum working pressure in order to increase the power tool,
Targeting tools toward your other persons or animals,
Purging clothing from dirt and dust with compressed air,
Touching the equipment in motion,
Admission to work in his position any person without the knowledge of the superior, especially without the
proper preparation of substantive.
Repairing own devices,
Repair, adjust or replace the tool tip during operation,
Cutting off the flow of air through the hose collapses,
Resting your elbows on the body while the pneumatic tool to increase pressure.
K.
AFTER OPERATION.
Stop the supported devices, thoroughly clean work station.
Place of instruments and tools in it for.
Make sure the left post and the device will not create any threat to the environment.
L.
MAINTENANCE AND REPAIR.
Repair of pneumatic tools should be conducted in a workshop servicing by qualified personnel.
7.
Preparing the air
When working with pneumatic tools necessary to properly prepare the air. It should be used:
Pressure regulators are necessary to set the proper pressure tool.
Water filter for a minimum of 40 micron filtration. The dry air protects the tool from rust and protects them from
damage and malfunction.
Where necessary, the air should be lubricated. Use oil designed specifically for pneumatic tools.
Capacity of the compressor Compressor should have a capacity of at least 50% higher than the air consumption
given in the technical parameters tool.
