D112 EN
–
2021 05 01
4
www.facespa.it
3. SLIDING DOORS BREAK-OUT SYSTEM
3.1 ASSEMBLY PROCEDURE FOR KBS1E KIT
Assemble the components in the kit KBS1E on the sliding door as shown below.
The vertical sizes of the leaf are indicated in Fig. 4. The horizontal sizes of the leaf are indicated in Fig. 6.
Note: the KBS1E kit break-out is designed to be assembled on the sliding doors in which the vertical profile has a minimum
chamber of 30 x 33 mm.
Step
Ref. Description
1
B
Insert the pole (L) into the hinge pole (B) using the 8 x 35 mm elastic pin.
2
-
Make nr.6 holes d.6,5mm, on the vertical profile of leaf for attaching the hinge pole (B), respect the
measurements shown in Figure 1.
3
-
Make nr.2 slots d.5x15mm, on the vertical profile of leaf for attaching the lower pin (C), respect the
measurements shown in Figure 1.
4
A
Cut profile (A) and their brushes to measure Lm, and secure it at the top of the leaf, by screws not supplied
by us.
Note:
in case of doors with 2 leaves, it’s preferable to cut the profile few millimetres longer (Lm +2), to cover
the gap which is determined in the upper part of the doors closed position.
5
B
Insert the hinge pole (B) in vertical profile and secure with the provided screws, in correspondence of the
drilled holes in step 2.
Note: lubricate the hinge pole before insert.
6
C
Insert the lower pin (C) in vertical profile and secure using the supplied screws, in the slots made in step 3.
7
D
Cut profile (D) and their brushes to measure Lm, insert it into the hinge pole (B) and secure with the provided
screws.
Note:
in case of doors with 2 leaves, it’s preferable to cut the profile few millimetres longer (Lm +2), to cover
the gap which is determined in the upper part of the doors closed position.
8
E
Secure the coupling pin (E) on the profile (A) at the top of the door, respect the measurements shown in
Figure 1.
9
F
Insert the coupling pin (F) on the profile (D), using the provided screws, respect the measurements shown in
Figure 1.
10
G
Fix the heads (G) to the profile (D) with the provided screws.
Summary of Contents for KBS1D
Page 5: ...D112 EN 2021 05 01 5 www facespa it FIGURE 1 KBS1E assembly drawing...
Page 8: ...D112 EN 2021 05 01 8 www facespa it FIGURE 6 KBS1E horizontal sizes...
Page 9: ...D112 EN 2021 05 01 9 www facespa it FIGURE 7 KBS1D horizontal sizes...
Page 11: ...D112 EN 2021 05 01 11 www facespa it FIGURE 8 KBS1D assembly drawing...
