2
12mm x 1.75x70mm Bolt
Sway Bar End Link
2
12mm x 1.75 C-Lock Nut
6
1/2" USS Flat Washer
2
3/8"-24 C-lock Nut
7
Adel Clamp (FTCLAMP)
ABS Lines
2006 Toyota FJ Cruiser 2WD & 4WD
FTS26016BK / FTS26017BK / FTS26018BK
READ ALL INSTRUCTIONS THOROUGHLY FROM START TO FINISH BEFORE BEGINNING INSTALLATION! IF
THESE INSTRUCTIONS ARE NOT PROPERLY FOLLOWED, SEVERE FRAME, DRIVELINE AND / OR SUSPENSION
DAMAGE MAY RESULT.
NOTE: PRIOR TO THE INSTALLATION OF THIS SUSPENSION SYSTEM A FRONT END ALIGNMENT MUST BE
PERFORMED AND RECORDED. DO NOT INSTALL THIS SYSTEM IF THE VEHICLE ALIGNMENT IS NOT WITHIN
FACTORY SPECIFICATIONS. CHECK FOR FRAME AND SUSPENSION DAMAGE PRIOR TO INSTALLATION.
CHECK ALL PARTS INCLUDED IN THIS KIT TO THE PARTS LIST ABOVE BEFORE BEGINNING INSTALLATION OF
THIS KIT. IF ANY PARTS ARE MISSING, CONTACT FABTECH AT 909-597-7800
DO NOT ALTER THE FINISH OF THESE COMPONENTS, EXAMPLE- CHROMING, ZINC PLATING OR PAINTING.
CHANGING THE FINISH CAN CAUSE STRUCTURAL FATIGUE
OF COMPONENTS.
THIS SUSPENSION SYSTEM WILL NOT WORK ON TRUCKS EQUIPPED WITH ELECTRONIC CONTROLLED SHOCK
ABSORBERS
IF INSTALLING THE OPTIONAL DIRT LOGIC COILOVER, RECORD THE RIDE HEIGHT OF THE VEHICLE SO THAT
THE PROPER RIDE HEIGHT CAN BE DONE WHEN COMPLETED
YOU MUST RUN A 17X8 RIM OR LARGER WITH A 4 5/8” BACK SPACING WITH THIS KIT FOR PROPER WHEEL
CLEARENCE. 16” RIM WILL NOT FIT THE TRUCK ONCE THE KIT IS INSTALLED.
WELDING REQUIRED
VERIFY DIFFERENTIAL FLUID IS AT MANUFACTURES RECOMMENDED LEVEL PRIOR TO KIT INSTALLATION.
INSTALLATION OF THE KIT WILL RE-POSITION THE DIFFERENTIAL AND THE FILL PLUG HOLE MAY BE IN A DIFFERENT
POSITION. (FOR EXAMPLE, IF THE MANUFACTURE RECOMMENDS 3 QUARTS OF FLUID, MAKE SURE THE DIFF HAS 3 QUARTS
OF FLUID). CHECK YOUR SPECIFIC MANUAL FOR CORRECT AMOUNT OF FLUID.
TOOL LIST: (NOT INCLUDED)
•
FLOOR JACK & JACK STANDS
•
ASSORTED METRIC AND S.A.E SOCKETS, & WRENCHES
•
LARGE C CLAMP OR C CLAMP VISE GRIPS
•
DIE GRINDER WITH CUTOFF WHEEL OR SAWZALL
