INSTRUCTIONS:
1.
Disconnect the negative terminal on the battery. Jack up
the rear end of the vehicle and support the frame rails
with jack stands. Supporting the rear differential remove
and discard the rear shocks and u-bolts. Lower the axle
down slowly. Use care not to over extend the brake hose
.
NEVER WORK UNDER AN UNSUPPORTED
VEHICLE!
2.
Locate the factory emergency brake cable bracket on the
driver’s side rear frame section and remove. Use a die
grinder with a cut-off wheel and cut the bracket ONLY.
Remove the bracket from the cable and discard with the
hardware. SEE PHOTOS BELOW
3.
Clamp the leaf spring in the middle of the spring and
remove the center bolt. (DO NOT REMOVE THE LEAF
SPRING FROM THE TRUCK)
4.
Separate the individual leafs and install the provided
FT30275 add a leafs with the new center bolt in a
pyramid pattern smallest on the bottom graduating to the
longest on top. Locate FT30284 Leaf Spring Spacer and
place on the bottom of the stack. Clamp the spacer and
springs and tighten the center bolt as not to leave a gap
between the springs. Cut the thread of the bolt smooth
with the nut. The nut should be on the top of the leaf
spring pack. SEE DRAWING ON NEXT PAGE
