INSTALLATION INSTRUCTIONS
Natural Woven Shades
DuoShade
Common Fasteners
(Not included)
Outside Mount
Natural Woven Shades
Installation Instructions
DuoShade
Thank you for purchasing your new Natural Woven Shade.
It has been custom-made from the highest quality materials
to the dimensions you specified. With proper installation and
care, it will provide you with many years of beauty and trouble-
free use.
Please read all instructions before you start so you will be familiar
with the overall process.
Getting Started
Remove the shades from the packaging but do not dis-
pose of the packaging until the shades are installed to
your satisfaction.
As much as possible, leave the shades in their factory configura-
tions as they come out of the boxes. However, for cord and
pulley or cord lock lifting systems, depending on the placement
of the cords, you may need to remove the T pins immediately to
avoid damaging the cords during installation. Leave the straps
around the roll shade until it is installed.
Tools
Hardware
Check to make sure you received the brackets and screws
shown in the diagram. Keep in mind that the brackets must
be securely attached to the wall or other mounting surface,
preferably by drilling the screws into wood studs. If studs
are not available, you will need to purchase special fasteners
designed for your situation (see illustration for examples of
common fasteners).
• Pencil
• Awl
• Tape measure
• Level
• Ladder or stepstool
• Motor tester (if shade
is motorized)
• Power drill with the following bits:
–
¹⁄
16
" drill bit
–
¹⁄₈
" drill bit
–
¹⁄₄
" hex driver
– Phillips screwdriver
– Masonry drill bit (if drilling
into concrete or brick)
