Step 3: Attach the Rollstar Shade
Remove the Rollstar shade from its packing, but leave the
shade rolled up.
Chain and Clutch Lifting System—Attach the shade to the
headrail, clutch end first. Push the clutch onto the bracket
spear. Lift the idler end up under the headrail and drop the
idler end pin into the bracket. Rotate the latch to lock it into
place.
Motorized Lifting System—First
place the idler end in its
bracket on the headrail. Then, drop the motor end into its
bracket, making sure the limit switches are easily accessible.
Insert the cotter pin in the motor end.
Clutch end Idler end
Idler end Motor end
Latch
Step 4: Finish the Installation as Described on Back Page
Outside Mount
Step 1: Determine Shade and Bracket Locations
Center the shade over the opening at the desired height.
Mark the location of the headrail on the wall.
Cotter pin
Latch
Step 3: Attach the Natural Woven Shade
Drill
¹⁄
16
" pilot holes at each bracket hole location. Attach the
brackets to the wall using the long hex head screws provided
or the appropriate fastener. Place the shade over the brackets
and push it back against the wall or window frame. Center
the headrail over the window. Check that the draw cord is not
snagged and moves freely around the brackets, and that the
headrail is level. Holding the shade in place, pierce the fabric
using an awl and then drill the headrail through the bracket
mounting holes using a
¹⁄
16
" drill bit. Attach the headrail to
the brackets using the short hex head screws provided.
Step 2: Mark the Bracket Mounting Positions
Mark the bracket mounting positions below the headrail position
as shown. Place a bracket about 3" from each end of the
headrail and make sure the brackets are level with each other.
If you are installing a wide shade, space additional brackets
equally across the top, no more than 36" apart, and be sure
they are level with the end brackets.
Step 4: Attach the Rollstar Shade
Remove the Rollstar™ shade from its packing, but leave
the shade rolled up.
Chain and Clutch Lifting System—Attach the shade to the
headrail, clutch end first. Push the clutch onto the bracket
spear. Lift the idler end up under the headrail and drop the idler
end pin into the bracket. Rotate the latch to lock it into place.
Clutch end Idler end
