FabiaTech Corporation
IDE Configuration
You can use this screen to select options for the IDE Configuration Settings. Use the
up and down <Arrow> keys to select an item. Use the <Plus> and <Minus> keys to
change the value of the selected option. A description of the selected item
appears on the right side of the screen. The settings are described on the following
pages. An example of the
IDE Configuration
screen is shown below.
¾
Onboard PCI IDE Controller
This item specifies the IDE channels used by the onboard PCI IDE controller
Available Options:
Primary, Secondary, Both and Disable
Default setting:
Both
Primary/Secondary IDE Master/Slave
IDE hard drive controllers can support up to two separate hard drives. These drives
have a master/slave relationship, which is determined by the cabling configuration
used to attach them to the controller.
LBA/Large Mode
LBA (Logical Block Addressing) is a method of addressing data on a disk drive. In
LBA mode, the maximum drive capacity is 137 GB. The Optimal and Fail-Safe
default setting is
Auto
Hard Disk Type
The BIOS supports various types for user settings, The BIOS supports <Pri Master>, <Pri
Slave>, so the user can install up to two hard disks. For the master and slave
jumpers, please refer to the hard disk’s installation descriptions and the hard disk
jumper settings. You can select <AUTO> under the <TYPE> and <MODE> fields. This
will Enabled auto detection of your IDE drives during boot up. This will allow you to
change your hard drives (with the power off) and then power on without having to
reconfigure your hard drive type. If you use older hard disk drives, which do not
27
Summary of Contents for Low Power FB2403
Page 6: ...vi...
Page 58: ...FabiaTech Corporation 52...
Page 79: ...FabiaTech Corporation Appendix Dimension Top Side 73...
