Faber TheTUBE, Installation And User Manual

Page: 5 / 12

4 < < < <
L
3.3 Move the appliance
Use the supplied handle if you want to move
the tube (see Figure 1.7)
• Secure using the supplied pin.
• Switch off the Tube
4 Installation guide
4.1 supplied
Remove the rear wall plate and take out loose
parts from the wrapping and check The Tube
for possible damages incurred during
transport. (Report such damages to your
supplier.)
You will find :
1. Instruction manual
2. cover
Not supplied :
1. A gas bottle
2. an approved gas hose with a …..
mbar pressure regulator. (See
the Technical specifics for the
correct pressure)
3. Security chain.
4.2 gas connection
Please take the installation requirements into
account. (chapter 3)
Propane bottle :

Open the gas bottle space by
removing the access plate (see fig.
1.1 B )

Attach the gas hose to the pressure
regulator by means of a hose clamp.

Fix the other end in the same way to
the threaded insert attached to the
gas control tap. (see fig. 1.3)

Remove the seal on the gas bottle.

Connect the pressure regulator to the
gas bottle.

Check the entire gas connection for
leakages.

Now place the gas bottle into the
space and fasten it with the web
sling. (see fig. 1.1 C )

The gas bottle can be opened now.
Natural gas :

Make sure you have an easily
accessible gas tab outside The Tube .

Use a stability chain. This will keep
The Tube from moving and prevent
damage to the flexible hosing, for
assembling you can use the holes in
the bottom plate.

Disconnect The Tube if you plan to
move The Tube .
4.3 Removing glass
Remove the top plate of the Tube and on
screw the mounting bracket and remove the
four glass clips away, the glass can now be
removed. (Fig 1.2 A , 1.2 B en 1.2 C)
Replacing the glass is done in reverse order.
Remove all Fingerprints from the glass, these
will be burnt into the glass when The Tube is
in use.
5 User manual
The Tube has been provided with a control
valve with an inbuilt ignition for the pilot
light.
The level of the flame can be adjusted
accordingly.
The control panel is located at the back
behind the access plate. (see fig. 1.4)
5.1 Ignition pilot light

turn the knob of the control valve in
the OFF-position

Open the gas bottle.

Press the knob and turn it to the
position. You will hear a click and a
spark will appear which should ignite
the pilot light.

If the pilot does not light then repeat
procedure

Keep pressing the knob down for
about ten seconds after the ignition
of the pilot light.

Let go of the knob and check whether
the pilot light remains alight.
5.2 Igniting and regulating the main
burner.

Turn the knob to the big flame, the
main burner will ignite and the level
of the flame can be continuously
adjusted now.

By turning the knob to the small
flame the flame picture will go
lower

By turning to the ……..again the main
burner will go to the out position