Faber TCH04, Manual

Page: 2 / 84

2
EN - SAFETY INFORMATION - For your safety and correct operation
of the appliance, read this manual carefully before installation and use.
Always keep these instructions with the appliance even if you move or
sell it. Users must fully know the operation and safety features of the
appliance. The wire connection has to be done by specialized techni-
cian. The manufacturer will not be held liable for any damages resulting
from incorrect or improper installation. The minimum safety distance
between the cooker top and the extractor hood is 650 mm (some mod-
els can be installed at a lower height, please refer to the paragraphs
on working dimensions and installation). If the instructions for installa-
tion for the gas hob specify a greater distance, this must be respected.
Check that the mains voltage corresponds to that indicated on the rating
plate fixed to the inside of the hood. Means for disconnection must be
incorporated in the fixed wiring in accordance with the wiring rules. For
Class I appliances, check that the domestic power supply guarantees
adequate earthing. Connect the extractor to the exhaust flue through a
pipe of minimum diameter 120 mm. The route of the flue must be as
short as possible. Regulations concerning the discharge of air have to
be fulfilled. Do not connect the extractor hood to exhaust ducts carrying
combustion fumes (boilers, fireplaces, etc.). If the extractor is used in
conjunction with non-electrical appliances (e.g. gas burning applianc-
es), a sufficient degree of aeration must be guaranteed in the room in
order to prevent the backflow of exhaust gas. When the cooker hood
is used in conjunction with appliances supplied with energy other than
electric, the negative pressure in the room must not exceed 0,04 mbar
to prevent fumes being drawn back into the room by the cooker hood.
The air must not be discharged into a flue that is used for exhausting
fumes from appliances burning gas or other fuels. If the supply cord
is damaged, it must be replaced from the manufacturer or its service
agent. Connect the plug to a socket complying with current regulations,
located in an accessible place. With regards to the technical and safety
measures to be adopted for fume discharging it is important to closely
follow the regulations provided by the local authorities. WARNING: Be-
fore installing the Hood, remove the protective films. Use only screws
and small parts in support of the hood. WARNING: Failure to install the
screws or fixing device in accordance with these instructions may re -
sult in electrical hazards. Do not look directly at the light through optical
devices (binoculars, magnifying glasses…). Do not flambè under the
range hood; risk of fire. This appliance can be used by children aged
from 8 years and above and persons with reduced physical, sensory