Faber Presence, Installation Manual And User'S Manual, Page: 21 / 24

20 < < < <
UK IRL
pressing the OFF- key (fig. 2.0) or
wait for ten seconds.
•
Press the SET–key (fig. 1.8) again and
now P2
Ï
(homecoming) will appear
in the display screen, the time
indication will start to blink and now
set the starting time.
•
Press the SET–key (fig. 1.8) again,
now P2
d
(night) appears in the
display screen, the time indication
will start to blink and now set the
starting time.
•
Save the settings by pressing the OFF-
key (fig. 2.0) or wait for ten seconds.
22 Checkpoints in case of
Malfunction
If the remote control unit of the fire does not
function properly, check the following points
first:
1. Is the toggle switch (fig. 1.1) set to
position I ?
2. Check the battery- (chapter. 18.5)
3. Check whether the receiver responds
to the remote control unit.
If necessary, reset the receiver.
Therefore:
Briefly pull the battery pack out and
remove the batteries out the holder
wait 1 min. before replacing the
batteries , now the receiver is reset.
If the remote control unit or the fire itself
does not function properly after all these
checks, we refer you to your gas fitter.