Faber MatriX 1050/500 I, Installation Manual

Page: 23 / 44

Installation manual MatriX 1050/500 I,II,III H & MatriX 1050/650 I,II,III H
23 < < < <
Found value
………………………………
………………….. mm
Mark
Install the air restrictor plate, see installation manual. 0,1
Install adapter 100/150 direct on top of the fire. 0,2
In case of wall terminal, install adapter 100/150 before the last bend,
incase of roof terminal just before the terminal.
0,3
In case of roof terminal (always size 100/150) install the 100/150 adapter
just before the terminal. In case of wall terminal always 130/200.
0,4
Install from the fire first an adjuster to 130/200 and 1 meter 130/200, after
that reduce to 100/150 again and continue with 100/150.
0,5
Restrictor size = Value for the comma
Extra information = Value behind the comma
Search in the table at TVH and THL and enter the value that is found.
If the detected value is a number, check whether the completed STL is higher or equal to the value in the
table.
Is the STL value lower as specified in the table then the installation is not possible.
Solution: Start length to low, see for the minimum length in the top row of the table.
Is the found value X, then the installation is not possible.
Solution: Change the TVH or THL.
Results