Faber Blokhus, Installation Manual, Page: 29 / 36

Installation manual Blokhus (Extension modules & HE-module)
28 < < < <
19.1 Installation requirements

The distance between the top of the
appliance to the ceiling must be at least
250mm.

When an extension module single is used
in combination with extension module(s),
double, the single must be installed on
top.

The back panel of an extension module
double has cut outs which can be
removed in case of a wall terminal or back
outlet (see dimensional drawing 20.2).

The appliance can be fitted to the wall by
using the supplied wall bracket (see
dimensional drawing 20.3).

An HE-module must be at least installed in
combination with an extension module
double (see dimensional drawing 20.0,
20.4 and 20.5).
19.2 Preparation and installation instructions
Preparation
Fireplace:
Remove the top plate and the rear inlay part.
After mounting the extension modules, these
must be placed on the top module.
Extension module(s):

Loosen screws A on the inside to remove
the panels from the extension modules
(fig. 1.0).

If necessary the back panel(s) can be
removed by loosening screws B (fig. 1.0).

Remove the upper panel of the fire by
loosening screws A (fig. 1.0).
Installation instructions
HE-module:
Before mounting the extension module(s),
place the HE-module first (fig. 4.0).
Extension module(s):

Mount the first extension module on the
fire with the included bolts and nuts (fig.
2.0).

Install the first flue pipe on the fire.

If necessary fit the back panel with the
screws B.

Place the panels of the extension
module(s) back and lock these again with
the screws A.
The other modules can be fitted in the same
way.

If necessary the complete fire can be
fitted to the wall with the supplied wall
bracket (fig. 3.0 and dimensional drawing
20.3).
The screws to mount the wall bracket on the
fireplace are included, the screws to mount
the wall bracket on the wall are not, they
depend on the wall construction.