Faber BELLA IS Series, Installation Instructions; Use And Care Information

Page: 16 / 40

16
USE AND CARE INFORMATION
For Best Results
Start the rangehood several minutes before cooking to develop proper airflow. Allow the rangehood to
operate for several minutes after cooking is complete to clear all smoke and odors from the kitchen.
Button Function Display
A Turns the suction motor on and off at speed one. Displays the set speed
B Decreases the working speed. Displays the set speed
C Increases the working speed. Displays the set speed
D Activate intensive speed from any other speed,
including motor off. This speed is set to operate for
6 minutes, after which the system returns to the
speed that was set before. Suitable to deal with
maximum levels of cooking fumes.
Displays HI and the time remaining once very
second.
Press and hold the button for approximately 5
seconds, with all the loads turned off (Motor and
Lights), to turn the Activated Charcoal Filter alarm
On and Off.
FC+Punto (2 flashes)–Alarm On.
FC+Punto (1 flash)–Alarm Off.
E
24H function
Turns the suction motor on at speed one and effects
one 10 minute extraction every hour.
Displays 24 and the spot at the bottom right flashes
once every second, while the motor is running.
It is disabled by pressing the button.
When the filters alarm is triggered, the alarm can
be reset by pressing and holding this button for
approximately 3 seconds.
These indications are only visible when the motor
is turned off.
FF flashes three times.
When the procedure terminates, the indication
shown previously turns off:
FG indicates the need to wash the metal
grease filters. The alarm is triggered after the Hood
has been in operation for 100 working hours.
FC indicates the need to change the
activated charcoal filters, and also to wash the
metal grease filters. The alarm is triggered after the
Hood has been in operation for 200 working hours.
F Delay function
Activate automatic switch-off with a 30’ delay.
Suitable to complete elimination of residual odours.
Can be activated from any position, and is disabled
by pressing the button or turning the motor off.
Displays the operating speed and the spot at the
bottom right flashes once a second.
Press and hold the button for approximately 5
seconds, with all the loads turned off (Motor and
Lights), to turn the Remote Control On and Off.
IR+Punto (2 flashes)– Remote Control On.
IR+Punto (1 flash)– Remote Control Off.
G
Turns the lighting system on and off at maximum
intensity.
H
Turns the Courtesy Lighting on and off.