Version 03/08- Page 8
FIGURE 14
9.
The chimney must be attached to the body of the rangehood, as indicated in
FIGURE 12
. The UPPER CHIMNEY COVER
(C)
must be installed first, then the LOWER CHIMNEY COVER
(B)
wraps around it. Both sections are secured to the wall under the
CHIMNEY MOUNTING BRACKETS
(H)
. Secure the UPPER CHIMNEY COVER to the MOUNTING BRACKETS with the CHIMNEY
SCREWS
(J)
. Secure the LOWER CHIMNEY COVER to the CANOPY SECTION
(A)
with the CHIMNEY SCREWS
(J)
.
FIGURE 12
10.
Turn the power supply on. Turn on blower and light. If the rangehood does not operate, check that the circuit breaker is not
tripped or the house fuse blown. If the unit still does not operate, disconnect the power supply and check that the wiring connec-
tions have been made properly.
USE AND CARE INFORMATION
This rangehood system is designed to remove smoke, cooking vapors and odors from
the cooktop area.
For Best Results
Start the rangehood several minutes before cooking to develop proper airflow. Allow the
unit to operate for several minutes after cooking is complete to clear all smoke and odors
from the kitchen.
Cleaning
The metal grease filters should be cleaned frequently in hot detergent solution or washed
in the dishwasher. Stainless steel cleaner should be used on stainless rangehoods.
Abrasives and scouring agents can scratch stainless steel finishes and should not be
used to clean finished surfaces.
Replacing the Lamps
Before attempting to replace the lamps, make sure that the light switch is turned off.
Remove the 2 screws
(as indicated in FIGURE 14)
that hold the light support and gently
pull the support down from the hood. Remove the lamp from the light support and replace
with new lamp. Replace the light support and fix it into place with the 2 screws.
An alternative method to replace the lamps is to use a 1 1/4" suction cup (
FIGURE 15
).
Attach the suction cup to the bulb and pull firmly down on the bulb and replace with a
new lamp.
FIGURE 15
Summary of Contents for 280 CFM
Page 16: ......
