Faber 106/35 PLUS, Instruction Manual

Page: 8 / 24

EN
8
8
HOW TO FIX THE FINISH PANELS
• Pull the metal visor by rotating it forward, unlocking at the
same time the lock which is fixed outside the hood.
• Lean the visor on the frontal finish panel, line it as you need if
necessary, join the visor together to the eventual visor exten-
sion, by taking it between the panel and the visor before fixing
all pieces with the supplied screws.
• Fix the lateral finish panels.
WALL FIXATION
• The hood depth can vary between 275 and 360 mm.
• Adap the Vx screw to the bracket to necessary depth.
• In order to adapt the lower part of the hood to the necessary
depth, loosen the screws from the metal spacer and move it till
necessary.
• Drill the wall as per drawing, apply the dowels in the holes and
fix the metal.
Brackets with four Screws furnished with accessories.
In case the hood is in Exhausting version, remove the grid on the
air Duct
• Fix the Hood to the metal bracket.
• Reassemble the visor by carefully inserting the tracks in their
places. Regulate the visor sliding moving the screws
• Agendo sulle Viti
Vy
si potrà allineare la Cappa in altezza ris-
petto ai pensili vicini.
• By adapting the
Vy
screws, you will regulate the height of the
hood with regards to the furniture
• If necessary you can also regulate the Hood depth.
• Lean the security square above the fixing brackets
• Mark the centre of the holes.
• Drill wall and fix the security squares with furnished Screws
and dowels.
275-360 mm
Vx
Vy
Vx
Vy
Min. 530 mm
Max. 750 mm
639 (Mod. da 90cm)
539 (Mod. da 60cm)
80
207