LED
Microwave motion sensor
24.150 GHz
2
<< 5mW/cm
+/- 10 to 50 cm if movement towards sensor at 90° (adjustable)*
Motion (bidirectional)
Min. 5Hz or +/- 3cm/s, Max. 200Hz or +/- 1.2m/s
12 - 24V AC +/- 10%
12 - 24V DC +30% / - 10%
50 - 60 Hz
< 1.2W
Relay with switch-over contact (free of potential)
48V AC - 60V DC
1A (resistive)
30W (DC) / 48VA (AC)
0.5s (in PULSE mode)
-20°C - +55°C
IP30 with cable connected
IP40 flush-mounted without front face
Ip52 flush-mounted with front face and silicone seal
IP52 mounted in surface mount box
R&TTE: 1999/5/EC; EMC:
2004/108/EC
ABS / PC
White
2
Stranded cable up to 16 AWG - 1.5mm
Technology:
Radiated frequency:
Radiated power density:
Detection range (hand):
Detection mode:
Speed of target to create detection:
Supply voltage:
Mains frequency:
Power consumption:
Output:
Max. voltage:
Max. current:
Max. switching power:
Output hold time:
Temperature range:
Degree of protection:
Norm conformity:
Material:
Colour:
Recommended wiring cable:
SYMPTOM
POSSIBLE CAUSES
CORRECTIVE ACTION
TROUBLESHOOTING
TECHNICAL SPECIFICATIONS
Specifications are subject to changes without prior notice
* The adjustment of the detection field below 10cm is possible, but the detection capability of the sensor can not be guaranteed!
3/4
Bad or no power supply
Wrong connection
Wrong connection
Wrong connection
Wrong output mode
Switch the output mode
to PULSE mode.
Detection range is too small.
The environment influences
the good functioning of the sensor.
Adjust the detection range.
Remove any moving objects close
to the sensor.
Check wiring and relay connection.
Check wiring and relay connection.
Check wiring and relay connection.
Check power supply.
The door does
not open even when
moving hand
towards the sensor.
The door remains
permanently open.
The door remains open
after
detection/activation.
If LED switches on or flashes,
power connection is OK.
Remove any metal plates
in front of the sensor.
OFF
ON
ON
ON
OFF
OFF
OFF
