2/4
4
6
5
1
2
3
10cm
50cm
7
8
9
T
P
10cm
50cm
POWER
COM
NO
NC
50mm
70mm
“click”
“click”
SILICONE
Make a hole as indicated and
insert the recessed box into the
opening. Pull the wires through
the box.
If you do not use the fixation
brackets, unscrew them.
Fix the screws of the recessed
housing in the oval holes.
Insert the housing into the
recessed box and tighten the
screws firmly.
Make sure the output mode is set to PULSE-mode (P) for standard door applications.
Adjust the detection range according to the application.
Note that the detection range depends on the trajectory, size and
nature/material of the detected object.
Connect the wires to the
terminal block. After
connection, the LED flashes.
In order to increase water
resistance, place a silicone seal
on the front cover.
Clips the front cover on the
fixation braket. Make sure the
zone for the LED is at the
bottom, otherwise you risk
damaging the front face when
trying to clips it.
Make sure the LED-signal is
visible and test the good
functioning of the sensor by
moving the hand towards the
sensor.
TOGGLE MODE
PULSE MODE
: Recommended for
switch applications. In toggle mode, a
detection activates the relay and a
second detection deactivates it again. In
door applications, the door stays open
after the first activation.
: Recommended for
automatic door applications. In pulse
mode, a detection activates the relay for
a short period of time (depending on the
duration of the movement in front of the
sensor).
RELAY ON
RELAY OFF
RELAY ON
RELAY OFF
INSTALLATION
min. 1s
DOOR OPENS
DOOR OPENS
AND CLOSES
DOOR OPENS
AND CLOSES
DOOR CLOSES
