TM2 X TT-50
28
A4518_6H04_Rev.A
STORING OF THE FIRST REMOTE CONTROL
ATTENTION! This programming is only necessary when the receiver (motor or control unit)
is installed for the fi rst time, that is to say, when the receiver has not yet been connected
to any remote control.
Otherwise, see: “STORING OF OTHER REMOTE CONTROLS”.
STORING OF OTHER REMOTE CONTROLS
Consult the following scheme in order to fi nd the procedure that meets your requirements:
To add:
To another device
created using:
Fun
ĐƟŽŶ͗
PROCEDURE:
Tn/Cn
LCDx
TM2 X TT-50
ADD FROM
TM2 X T
TM2 X TT-50
A+B; B
ADD FROM
LCDn
Tx/Cx
Another
remote control
TM2 X TT-50
ADD
TO
TM2 X TT-50
TM2 X T
ADD TO
B (2
sec)
LCDn
LCDx
TM2 X TT-50
(another) TM2 X TT-50
ADD TO +
ADD FROM
TM2 X TT-50
TM2 X TT-50
ADD TO
ADD FROM
1
2
3
Another
remote control
- LEGEND:
Tn / Cn: already stored remote control / channel (not LCD)
Tx / Cx: remote control / channel to be stored (not LCD)
LCDx: device to be stored on a LCD remote control
LCDn: device already stored on a LCD remote control
-Main menu / Programming / Devices / DEVICE CREATED / Store + STORE.
- After storing, use the UP / DOWN / STOP keys to check whether the motor is operating
correctly.
- After checking, press END PROCEDURE.
Before proceeding
make sure that the receiver (motor or control unit) is powered.
EN
