ASSEMBLING THE MOTOR
NB: If the tube has a circular section, the drive pulley must be fastened to the tube.
This must be carried out by the installer. For other types of profile, it is optional to
fasten it to the tube, even if it is strongly recommended to do so.
RING NUT ADAPTER
DRIVE PULLEY
RING NUT
1
2
3
1. Insert the adapter onto the ring nut
so that the groove is lined up with the
reference mark and push it on as far as
it will go.
2. Install the drive pulley on the shaft of
the motor until the detent spring clicks.
3. Insert the motor completely into the
winding tube.
TM2
PPR
17
A4518_6G85_Rev.A
EN